User`s guide

Getting Started
2-6
2.3 Connecting to Host
The subsystem supports the Ultra 320 SCSI LVD interface which provides fast
320MB/S data transfer rates using a 16-bit SCSI bus. Installation of the disk
array is very similar to the installation of a standard SCSI drive. The SCSI
connector accepts the standard 68-pin LVD SCSI connector used on most LVD
SCSI devices. Refer to your system and/or SCSI host adapter manual for addi-
tional installation procedures that may apply to your system or host adapter.
1. The package comes with two external SCSI cables. For every pair of host
channel SCSI connector at the rear of the subsystem, attach one end of
the external SCSI cable to one of the SCSI connectors and the other end
to the host adapter’s external SCSI connector. (The host adapter is in-
stalled in your Host subsystem.)
2. Connect the other host system using the other external SCSI cable if you
want to configure subsystem into multi-host attachment.
3. Monitor Port
The subsystem is equipped with a serial monitor port allowing you to connect
a PC or terminal.
4. Cooling Fan module
Two fans are located at the rear of the subsystem. They provide sufficient
airflow and heat dispersion inside the chassis.
5. Power Supply Unit
The power supply is located at the rear of the subsystem. Turn on the power
supply to power-on the subsystem. The “power” LED at the front panel will
turn green.