User`s guide

Getting Started
2-9
2.3 Connecting to SAS HBA
The subsystem supports SAS interface which provides fast 300MB data trans-
fer rate using SAS phy. This section describes the location of the host chan-
nels and instructions on connecting external SAS devices.
1. Configure the SAS port Mapping.
2. The package comes with two SAS cables. Attach one end of he SAS
cable to one of the SAS connectors and the other end to the host
adapter’s external SAS connector or to the SAS Hub/Switch.
(The host adapter is installed in your Host subsystem.)
3. Connect the other host system using the other SAS cable if you want to
configure subsystem into multi-host attachment.
!
Note:
For safety reasons, make sure the Disk Array and Host Computer
are turned off when you plug-in the SAS cable.
Host B
Host A