User`s guide

Getting Started
2-10
2.5 Install Hard Drives
This section describes the physical locations of the hard drives supported by
the subsystem and gives instructions on installing a hard drive. The subsystem
supports hot-swapping allowing you to install or replace a hard drive while the
subsystem is running.
1. Pull out an empty disk tray. (You can install in any available slot.)
2. Take off the bracket before installing hard drive.
Note:
Insert screws through the front sides of the mounting holes.
3. Place the hard drive in the disk tray.
4. Install the mounting screws on each side to secure the drive in the mobile
rack.