User`s guide

Getting Started
2-9
2.4 Powering-on the Subsystem
When you connect the Disk Array to the Host computer, you should press the
ON/OFF Power Supply Switch. It will turn the Disk Array on and the Self-Test
will be started automatically.
1. Plug in all the power cords or power connectors located at the rear of the
subsystem.
2. Turn on the power.
3. The “Power” LED on the front panel will turn green. After a few moments
the LCD should display the following message: “
*
” detecting the fibre
cable connect well.
{Model Name}
xxx.xxx.xxx.xxx
*
Power 1Supply
Power Supply 2
Power Switch
AC-1
AC-2
Note:
The subsystem is equipped with redundant PFC (power factor
correction), Full Range power supplies. The subsystem will automati-
cally selector voltage.
!