User manual
Fibre to SAS/SATA II RAID Subsystem
94
User Manual
5.5.11 Modify Password
To change or disable the RAID subsystem’s admin password, click on the Modify
Password link under the System Controls menu. The Modify System Password
screen appears.
The factory-default admin password is set to 00000000. Once the password has been
set, the user or administrator can only monitor and configure the RAID subsystem by
providing the correct password.
The password is used to protect the RAID subsystem’s configuration from
unauthorized access. The RAID controller will check the password only when entering
the Main Menu from the initial screen. The RAID subsystem will automatically go back
to the initial screen when it does not receive any command after sometime.
To disable the password, enter only the original password in the Enter Original
Password box, and leave both the Enter New Password and Re-Enter New
Password boxes blank. After selecting the Confirm The Operation option and
clicking the Submit button, the system password checking will be disabled. No
password checking will occur when entering the main menu from the starting screen.
NOTE: The admin Password characters allowed are ‘A’ – ‘Z’, ‘a’ – ‘z’,
and ‘0’ – ‘9’. The minimum number of Password characters is
null/empty (Password is disabled) and maximum number of
Password characters is 15.
5.5.12 Upgrade Firmware
Please refer to Section 6.2 for more information.