User manual

Fibre to SAS/SATA II RAID Subsystem
42
User Manual
4.2 Configuration through the LCD Panel
All configurations can be performed through the LCD Display front panel function keys,
except for the “Firmware update”. The LCD provides a system of screens with areas for
information, status indication, or menus. The LCD screen displays menu items or other
information up to two lines at a time. The RAID controller’s factory default password is
set to 00000000.
Function Key Definitions
The four function keys at side of the front panel perform the following functions:
Parts Function
Up and Down
Arrow buttons
Use the Up or Down arrow keys to go through
the information on the LCD screen. This is also
used to move between each menu when you
configure the subsystem.
NOTE: When the Down Arrow button
is
pressed 3 times, the LCD control will shift to
the other RAID controller (in redundant
controller mode) and the other RAID
controller’s IP address will be shown in LCD.
Select button
This is used to enter the option you have
selected.
Exit button EXIT
Press this button to return to the previous
menu.
NOTE: This button can also be used to reset
the alarm beeper. For example, if one power
supply fails, pressing this button will mute
the beeper.