User manual

Fibre to SAS/SATA II RAID Subsystem
32
User Manual
3.2 Disk Drive Installation
This section describes the physical locations of the hard drives supported by the
subsystem and give instructions on installing a hard drive. The subsystem supports
hot-swapping allowing you to install or replace a hard drive while the subsystem is
running.
3.2.1 Installing a SAS Disk Drive in a Disk Tray
NOTE: These steps are the same when installing SATA disk drive in
Single Controller Mode.
1. Press the Tray Open button and the Disk Tray handle will flip open.
2. Pull out an empty disk tray. Pull the handle outwards to remove the tray from the
enclosure.
3. Place the hard drive in the disk tray. Make sure the holes of the disk tray align
with the holes of the hard drive.
Tray
Open
Button