Specifications

SAP Recovery Kit
Description
NFS v4 cannot be configured with IPv6
IPv6 virtual IP gets rolled up into the NFSv4 heirarchy.
Solution: Do not use an IPv6 virtual IP resource when creating an NFSv4 resource.
NFS v4: Unable to re-extend hierarchy after unextend
Extend fails because export point is already exported on the target server. A re-extend to server A
of a NFS v4 hierarchy will fail if a hierarchy is created on server A and extended to server B,
brought in service on server B and then unextended from server A.
Solution: On server A run the command "exportfs -ra" to clean up the extra export information left
behind.
NFSv3: File Lock switchover fails on RedHat 6.x and CentOS 6.x
Attempting to fail over file locks on a server failover / switchover does not work with any RedHat
6.x or CentOS 6.x system. Lock failover with NFSv3 is currently not supported on these OS
versions.
Solution: Use the lock failover features available with NFSv4.
The Oracle Recovery Kit does not support NFSv4
The Oracle Recovery Kit supports NFSv3 for shared database storage. NFSv4 is not supported at
this time due to NFSv4 file locking mechanisms.
SAP Recovery Kit
Description
Failed delete or unextend of a SAP hierarchy
Deleting or unextending a SAP hierarchy that contains the same IP resource in multiple locations
within the hierarchy can sometimes cause a core dump that results in resources not being deleted.
To correct the problem, after the failed unextend or delete operation, manually remove any
remaining resources using the LifeKeeper GUI. You may also want to remove the core file from the
server.
Handle Warnings gives a syntax error at -e line 1
When changing the default behavior ofNoinHandle WarningstoYes, an error is received.
Solution: Leave this option at the default setting ofNo.Note:It is highly recommended that this
setting be left on the default selection ofNoas Yellow is a transient state that most often does not
indicate a failure.
Choosing same setting causes missing button on Update Wizard
If user attempts to update theHandle Warningwithout changing the current setting, the next
screen, which indicates that they must go back, is missing theDonebutton.
SteelEye Protection Suite for Linux239