Installation guide

APPENDIX

Software Drivers

• OS Independent

Physical/Electrical

SAS hard drives

• Up to 12/16 2.5-inch or 3.5-inch SAS hot-plug hard drives (6.0

Gb/s) at speeds of 10K or 15K rpm

SATA hard drives

• Up to 12/16 2.5-inch or 3.5-inch SATA hot-plug hard drives (6.0

Gb/s) at speeds of 7.2K or 10K rpm. Connectivity to the controller

system backplane is provided through an interposer assembly for

redundant controller.

Subsystem Controller Modules

• Controller board 1 or 2 modules

• Sensors 2 sensor per controller Board

Backplane Board

Connectors

• 12/16 SAS hard-drive connectors

• 2 power supply/cooling fan module connectors

• 2 sets of controller board connectors (3 connectors each control-

ler board)

Sensors

• 12/16 temperature sensors (one for each slot)

Controller Back-Panel Connectors

Host connectors (per controller board)

• 2 SAS CH0 and CH1 connector for connection to the host

• 4 Fibre CH0, CH1, CH2 and CH3 connector for connection to the

host

• 4 iSCSI CH0, CH1, CH2 and CH3 connector for connection to the

host

Expander connector (per controller board)

• 2 SAS “EXP 0 & EXP 1” connector for expansion to an additional

SAS JBOD enclosure

Management connector (per controller board)

• 2 6-pin UART RJ-11 connector