Installation guide
HARDWARE INSTALLATION
30
Figure 2-6 Connect SAS RAID subsystem and host adapter
2.6.2 Connecting Monitor Port
The SAS RAID subsystem is normally delivered with LCD pre-
installed. Your SAS RAID subsystem can be congured by using
the LCD with keypad, a serial device (terminal emulation) or LAN
port.
2.6 Connecting the RAID Subsystem
Once the SAS RAID subsystem has nished the installation of
hardware components, then you can connect it to a host computer.
The SAS RAID subsystem can be connected to a host computer
through the SAS, Fibre or iSCSI interface. User can select the
suitable cable connected to the host controller or other SAS JBOD
enclosure.
2.6.1 Connecting to Host System
The external host connector is provided on the back of the SAS
RAID subsystem for connecting the array to server host adapter.
By installing host port adapter and RAID subsystem using the
correct external cables which is included in your SAS RAID
subsystem kits. Then connect SAS RAID subsystem and host port
adapter as shown below: