Installation guide

HARDWARE INSTALLATION

Note:

There are two slots for your SAS RAID controller. If you only

installed one in your subsystem, the other empty slot must

place a cover. To remove the cover, pull out on the thin tabs

on each end of the cover and slide the cover out of the slot.

2.3.2 Removing the SAS RAID Controller from the

Subsystem

Follow the steps below to remove the SAS RAID controller from

the subsystem:

1. Loosen the thumbscrew on left side of the lever, then gently

but rmly pull the SAS RAID controller caddy out from the slot.

2. After removed the SAS RAID controller caddy from the subsys-

tem, place the cover in the empty slot.