Installation guide

HARDWARE INSTALLATION
23
b. Position interposer board with drive toward the interposer
board slot with the latch point in the interposer board aligned with
the interposer board slot. Gently press down the module until it
snaps into place in the interposer board slot on the tray.
c. Turn the drive tray upside down and using a screwdriver to se-
cure the drive to the drive tray by four of the mounting screws.
For 3.5-inch drive:
a. Slide the 3.5-inch drive toward the interposer board.
1. After installing the drive into the drive tray completely, make
sure the drive tray latch is open, then slide the drive tray with the
attached drive into the enclosure drive slot.
2. Gently slide the drive tray back of the enclosure drive slot until
the bottom of the open carrier handle makes contact with the
enclosure face plate.