Installation guide

HARDWARE INSTALLATION
20
2.2.1 Installing SAS/SATA Drives in the Enclo-
sure
Follow the steps below to install the 3.5-inch drives or 2.5-inch
drives into the drive tray.
a. Install the drives into the drive tray and make sure the holes of
the disk trays align with the holes of the drive.
b. Turn the drive tray upside down and using a screwdriver to se-
cure the drive to the drive tray by four of the mounting screws.
Figure 2-1. Put 2.5-inch
SAS/SATA drive into disk
tray
Figure 2-2. Put 3.5-inch
SAS/SATA drive into disk
tray
Figure 2-3. Drive carrier
with 2.5-inch SAS/SATA
drive
Figure 2-4. Drive carrier
with 3.5-inch SAS/SATA
drive
1. After installing the drive into the drive tray completely, make
sure the drive tray latch is open, then slide the drive tray with the
attached drive into the enclosure drive slot.
2. Gently slide the drive tray back of the enclosure drive slot until
the bottom of the open carrier handle makes contact with the
enclosure face plate.