Installation guide

HARDWARE INSTALLATION

Note:

Be careful when handling and storing the drives. The tray

provides some protection, but the drives and tray connectors

can be damaged by rough handling. When removing the

drives from the subsystem, place them on a padded surface.

Do not drop the drives.

3. The rack installation is complete.

2.2 Installing or Removing SAS/SATA

Drives in the Subsystem

Your enclosure supports up to 12 3.5-inch disk drives or 2.5-inch

SAS or SATA 6.0Gb/s drives, each one contained in its individual

drive carrier. Each drive is hot-pluggable, allowing you to remove

and insert drives without shutting down your subsystem.

This section describes how to install or remove drives in your sub-

system.