Installation guide

HARDWARE INSTALLATION

2.1 Installing an Subsystem into the Rack

or Tower (Option)

1. Using supplied screws to secure the mounting-bracket rail and

length rail and then secure them on the front vertical rail and rear

vertical rail, as shown below. Make sure that all connections are

tightened before continuing.

2. Slide the rear side of subsystem fully onto the rack until the sub-

system front panel touched the front vertical rails. Align the mount-

ing holes of the subsystem on the front vertical rail holes. Secure

the subsystem to the front vertical rail and mounting-bracket rail

on both sides. The subsystem is too heavy; it needs some assis-

tance from other people to lift it onto the rack together.