User manual

FIBRE-to-SAS/SATA RAID SUBSYSTEM

User Manual

For PRO-90-6601 SES board:

NOTE: The upgrade process is done twice. The first time needs a

jumper in JP8. The second time does not need a jumper.

1. Power off the RAID system. Remove the SES Module. Insert a jumper in JP8 of

SES board PRO-90-6601.

2. Insert the SES module into the RAID subsystem. Connect RS232 serial cable to

the RS232 port of SES module.

3. Power on RAID subsystem. Configure terminal settings as follows:

Baud Rate: 38400

Data Bits: 8

Parity: None

Stop Bits: 1

Flow Control: None

4. Open terminal console. Type “proses upgrade”.