User manual

FIBRE-to-SAS/SATA RAID SUBSYSTEM
26
User Manual
The firmware upgrade process for each type of SES board is different.
For PRO-90-5601 SES board:
1. Connect RS232 serial cable to the RS232 port of SES module.
2. Open terminal connection and configure terminal settings as follows:
Baud Rate: 115200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
3. In terminal console, type “proses reset” then immediately press “Q”.
4. Select “Transfer” then “Send File”. Use “Ymodem” protocol. Select the SES
firmware binary file. Click “Send” to start upgrade process.