User manual

FIBRE-to-SAS/SATA RAID SUBSYSTEM

User Manual

2.3.2 Features of the SES Module

The SES Module consists of 6 features: RS-232 Port, Alarm Mute Button, Dip

Switch, Enclosure ID dial, a Hard Contact Relay, and a System Light. These

features are described as follows:

1. RS-232 Port

The RS-232 port is for SES firmware upgrade.

NOTE: There are two types of SES board: PRO-90-5601 and PRO-

90-6601. Each has different Baud Rate setting. The LCD Display

Panel will show “SES” for PRO-90-6601 and “SES2” for PRO-90-

5601.

Below are the RS-232 settings.

Settings

Baud Rate

38400 (PRO-90-6601)

115200 (PRO-90-5601)

Data Bits 8

Parity None

Stop Bits 1

Flow Control None

2. Alarm Mute Button

When the audible alarm is sounding, press this button to mute the

audible alarm.

3. Enclosure ID Dial

The Enclosure ID Dial is used to indicate the ID number of that

particular enclosure.

Enclosure

Disk ID

Range

Used For

1 0 - 15 Default for 1

RAID Enclosure

2 16 ~ 31 Expansion (JBOD)

3 32 ~ 47 Expansion (JBOD)

4 48 ~ 63 Expansion (JBOD)

5 64 ~ 79 Expansion (JBOD)

6 80 ~ 95 Expansion (JBOD)

7 96 ~ 111 Expansion (JBOD)

8 Reserved Reserved

9 Reserved Reserved

0 Reserved Reserved