User manual

FIBRE-to-SAS/SATA RAID SUBSYSTEM
18
User Manual
2.2.2 Power Supply Module LED
When the power cord connected from main power source is inserted to the AC
Power Inlet, the power status LED becomes RED. When the switch of the PSFM is
turned on, the LED will turn GREEN. When the Power On/Fail LED is GREEN, the
PSFM is functioning normally.
2.2.3 Power Supply Installation
In this section, you will be shown how to install the Power Supply.
a. Check for damage, especially to the PCB Golden Fingers at the rear of the
Power Supply.
CAUTION! Handle the module with care and avoid damaging the
Golden Fingers. In addition, make sure there are no fingerprints on
the Golden Fingers. Do not install the module if the Golden Fingers
are damaged.