User manual

FIBRE-to-SAS/SATA RAID SUBSYSTEM
User Manual
123
9.2 Fibre Channel Config
The Administration Î Fibre Channel Config screen allows you to view the
current port configurations. The default port settings should be sufficient for most
standard configurations. However, you may need to change them if you encounter
problems with your configuration.
Each controller has two ports, which can either be connected directly to host’s HBA
or via a switch to the host systems. Each port can be configured with different
settings. They can negotiate different link speeds, ALPAs and requested topology.
Steps to configure Fibre Channel:
1. On the Administration Æ Fibre Channel Config screen, configure the
Preferred Address, Requested Speed, or Requested Topology as needed.
2. Click on Save Settings to save the changes.