Specifications

S 250 Cg
flange F 5g
=
63
Table Mounting
Goosenecks
S 250 Cg, RS 420 Cg, SRS 420 Cg
These goosenecks are used directly between capsules
and amplifiers of the Colette series. For mounting in a
table top, the AF 1 flange (not included) offers good
isolation from solid-borne noise. Mounting is generally
quite straightforward and simple.
A CUT 1 or CUT 2 variable low-cut filter can be
used on the amplifier – though the filter does not fit
into the AF 1, so it would have to “ride“ above the
table top.
S 250 Cg: When there is a particularly great need to
isolate the microphone from solid-borne noise, the
elastic suspension A 20 S can be used along with the
S 250 Cg. In an arrangement as shown at right, only
the gooseneck and capsule will be visible, and the sus-
pension will be relatively soft.
(S)RS 420 Cg: With the RS 420 and SRS 420 goose-
necks, two AF 1 flanged mounting adapters should be
used for stability, one above the other, with both
holding the microphone amplifier (e.g. CMC). For a
similar arrangement see the illustration at the bottom
of page 133.
Lengths:
S 250 Cg: 250 mm
RS 420 Cg: 420 mm, (rigid part: 317 mm)
SRS 420 Cg: 420 mm, (rigid part: 257 mm)
Other lengths or versions (e.g. older SKC models) are
available on request.
Surface finish: matte gray (g)
Goosenecks
RS 420 L5Ug and SRS 420 L5Ug
– special long (420 mm) gooseneck
– for use with any microphone of the CCM _L series
– output connector: XLR-3M
These goosenecks have a miniature Lemo plug for
CCM _L compact microphones at the upper end and a
short, rigid tube at the bottom. The tubing directly
above this rigid part is flexible. In the SRS version the
tubing near the upper end is flexible as well, allowing
the microphone's angle to be set.
To isolate the microphone from solid-borne sound,
due to the length of the gooseneck two AF 1 flanged
mounting adapters with internal shock mount should
be used, one above the other. These are held together
by an ST 20-3/8 mounting cylinder of at least 61 mm
length, with other lengths available on request; see
the illustration and explanation on page 133. The
cylinder is to be ordered separately.
Cable length: 5 m
Surface finish: matte gray (g)
CCM _L compact microphone
RS 420 L5Ug or SRS 420 L5Ug gooseneck
long version of the ST 20-3/8 mounting cylinder, pg. 116
2× AF 1 flanged mounting adapter, pg. 116
MK _ microphone capsule
S 250 Cg, RS 420 Cg or SRS 420 Cg gooseneck
CMC 6 Ug microphone amplifier, pg. 32
AF 1 flanged mounting adapter, pg. 116
COLETTE
modular
COLETTE
modular
CCM
compact
SRS 420 L5Ug
RS 420 L5Ug
RS 420 Cg, SRS 420 Cg
New!
New!
MK _ microphone capsule
S 250 Cg gooseneck
CMC 6 Ug microphone amplifier, pg. 32
A 20 S elastic suspension, pg. 57
F 5g table mounting flange, pg. 117