Specifications

56
Microphones on Stands
Dual Stand Clamp
SG 22
The angle between the micro phones can be varied as
well as the angle of inclination for the pair. However,
the SG 22 is not suitable for stereo pickups because of
the very limited range of angles and spacings possible
between the microphones. It is primarily intended for
holding a main microphone and a backup when extreme
operational security is required.
In the mid-position (shown at left) the microphones
are oriented perpendicular to the microphone stand. The
angle of inclination is +90° to -90° from the mid position.
Stand Clamp with Swivel
SG 20
– for a microphone of 20 or 21 mm diameter
(e.g. CMC, CMD, CMIT or CMBI)
The base of the SG 20 has a 5/8"-27 NS internal
thread. A threaded adapter is supplied for 3/8" and
1/2" mounting. The angle can be varied continuously
in the vertical plane.
Color: gray
SGC
Clamp made of
gray plastic material
– the unobtrusive
standard version
SGCM
All-metal clamp with
black chrome finish –
stable construction with
knurled screw for espe-
cially secure grip
Dual Stand Clamp
SG 22 MOD
Holds two microphones with 20 mm diameter in par-
allel alignment. Their distance can be varied from 4 mm
to 52 mm, while they can be oriented parallel to the
stand, perpendicular to the stand, or at any angle in
between.
Certain ”near-coincident” microphone arrangements
for stereo recording can be created in this way. With a
pair of CMC amplifiers placed upright side by side, later-
al ly-addressed Colette directional capsules (the MK 4V,
MK 41V, MK 6 and MK 8) can be used with any desired
angle set between their main axes. The other directional
capsules (the MK 4, MK 41 and MK 5) can be used
with GVC angle adapters; even some coincident micro-
phone setups are then possible.
COLETTE
modular
CCM
compact
COLETTE
modular
COLETTE
modular
COLETTE
modular
Miniature Stand Mount with Swivel
SGC, SGCM
– for CCM compact microphones or Active Cable with
microphone capsule
– adjustable from 0° through 100° in either direction
The internal thread of the SGC or SGCM screws onto
any 3/8" rod (e.g. vertical support rods STR) or stand
adapter.
The SGC is an integral part of the HC miniature cable
hanger and the TCg table stand.
Color: gray / black