Specifications

43
Active Accessories for the Modular System
M/S microphone arrangement
with RCY 1200 Active Stereo
Extension Tube and VST 62 ste-
reo microphone amplifier
Phantom-powered Stereo Microphone
Amplifier
VST 62 IUg
– for stereo recordings with the Active Stereo Cable or
the RCY Active Stereo Extension Tube (for M/S stereo)
– for 12 / 48 V phantom powering
– suitable for microphone cables of up to several hun-
dred meters
Surface finish: matte gray (g)
Accessories (optional):
K 30 STR stand support clamp for microphone ampli-
fiers, for attaching the VST 62 IUg to any 12 mm
rod (e.g. STR vertical support rod)
Mounting accessories for M/S, ORTF, X/Y:
see page 82 ff.
K 30 STR
VST 62IU
5-pin Binder
miniature plug (I)
KCY 250/0 Ig
Active Stereo Cable KCY for MK Capsules
for stereo microphone amplifier VST 62 IUg or stereo micro-
phone preamplifier VMS 5 U
Due to its unbalanced signal arrangement, the output
cable should be no longer than necessary. If longer
cables (up to several hundred meters) are required, the
VST 62 should be connected to a relatively short KCY
arrangement; it has balanced, low-impedance outputs
and can drive very long cables without interference.
Standard lengths:
KCY 250/0 Ig: input cable: 250 mm; output cable:
10 cm only, for use with an ex tension
cable (e.g. KS 5I; 5 m long)
KCY 250/5 Ig: input cable: 250 mm; output cable: 5 m
for direct connection without an exten-
sion cable
Other lengths are available on request.
250 mm
KCY with
HSGMSC cable
hanger for M/S
Technical Specifications:
Acoustical specifications: as stated for the MK micro-
phone capsules with the CMC 6 microphone
amplifier (page 134).
Phantom powering: 12 V ± 1 V and 48 V ± 4 V
(automatic changeover)
Current consumption per channel: 4 mA, indepen -
dent of the powering voltage
Maximum output voltage at 0.5% THD: 950 mV
(at 1 kHz and 1 kOhm load impedance)
Impedance: 60 Ohms
Minimum recommended load impedance: 600 Ohms
Low-cut frequency (-3 dB): 20 Hz
Maximum cable length: several hundred meters;
depends on the cable specifications
Length: 170 mm
Diameter: 30 mm
Weight: ca. 230 g
Output connector: XLR-5 (pin assignment see pg. 133)
COLETTE
modular