Specifications

116
Mechanical Accessories
Flanged Mounting Adapter with Internal
Shock Mount AF 1,
Mounting Cylinders ST 20-3/8 and STR-TC
This convenient elastic suspension device accepts any
microphone or accessory (such as a gooseneck) with a
20 mm diameter. A clamping arrangement holds the
item in place.
For use with our accessories, a mounting cylinder
(ST 20-3/8) with 20 mm outer diameter and a stud
with 3/8" threading is available. It has a hole drilled in
the center of its top which could be used to pass a
miniature cable through. To avoid the need for unsol-
dering and resoldering the cable connector, however,
two notches are also provided on the sides of the
adapt er. (Exception: the connector used at the ampli-
fier end of Colette Active Extension Tubes RC KC
won't fit through the 20 mm opening).
Dimensions: flange: 69 mm diameter
cylinder: 54 mm diameter,
29 mm depth below the flange
Color (cylinder and adapter): black
The ST 20-3/8 mounting cylinder must be ordered sep-
arately.
Stand Connector
RG 12
The RG 12 connects two STR vertical support rods or
any other rods with 12 mm in diameter. The angle
may be adjusted over a wide range.
Maximum length of the angled rod when a CMC is
fixed at the end and when no counterweight is used:
appr. 50 cm
Surface finish: matte gray
Vertical Support Rods
STR 250g, 350g, 600g, 1000g
These support rods have complementary 3/8" threads
on each end and can thus be screwed together in any
combination to extend one another. They can also be
attached to the floor stand BF 250.
A gray plastic cap is provided to allow covering the
upper threads of an STR if desired.
Lengths: 250 mm, 350 mm, 600 mm, 1000 mm
Diameter: 12 mm
Wrench size for tightening the rods (via flat spots at
the lower end): 10 mm
Surface finish: matte gray (g)
COLETTE
modular
CCM
compact
AF 1
notch
hole
STR-TC
ST 20-3/8
ST 20-3/8
- extended version
for two AF 1
SGC
pin with slot
– for clamping
mechanism