Specifications

111
Technical Specifications:
Filter: in-line low-pass, critical damping, 12 dB/octave
Cut-off frequency (-3 dB): 40 Hz
Output impedance: 40 Ohms @ 1 kHz with
SCHOEPS CCM compact microphones and CMC
standard Colette microphone amplifiers
Gain: 0 dB
Maximum output voltage (depends on current
drawn by microphone): ca. 1 V for 4 mA
Connectors: XLR-3
Dimensions: length: 94 mm, diameter: 20 mm
Suface finish: nickel
Inline Attenuators
MDZ 10, MDZ 20
– for phantom- or parallel-powered microphones
– ca. 10 dB / 20 dB constant attenuation
– avoids overloading sensitive inputs
– to be inserted between the microphone cable and
the phantom-power supply
– does not reduce the microphone's signal-to-noise ratio
Connectors: XLR-3F / XLR-3M
Dimensions: length: 75 mm; max. diameter: 19 mm
Color: black
Please note: With parallel-powered microphones, the
MDZ must be inserted between the powering unit and
the output cable.
Phantom Power Tester
PHS 48
– quick test of 48 V phantom powering (current)
– indication by a green LED
The PHS 48 can be plugged into a microphone input
or cable that carries 48-Volt phantom power, to verify
that sufficient current is available to power a SCHOEPS
microphone. According to the standards, a 48 V phan-
tom powered microphone may draw a current of up
to 10 mA per channel. SCHOEPS CMC 5, CMC 6 and
CCM microphones actually need only 4 mA (ca. 5 mA
if Active Accessories are used), so the PHS 48 tests for
approximately this amount of available current at the
required voltage level.
Connector: XLR-3M
Dimensions: length: 53 mm, diameter: 19 mm
Surface finish: nickel
Electronic Accessories
COLETTE
modular
CCM
compact