Instruction manual

Quick Setting Up Procedure

Receiver (RX) Setting Up

• Connect provided RX antenna (semi-rigid SMA antenna).

• Fit a PP3 9V Battery, check RX battery status LED.

• Connect Audio output cable and switch on power switch.

• If the battery status LED is AMBER replace RX battery.

• Set the receiver to the required operating frequency.

Interference Check

• Switch off TX - by disconnecting microphone cable.

• Observe signal strength indicator and listen for possible interfering signals from other transmitters

(slight flickering of the RF LED showing RED is acceptable). If there is very strong interference then

change the frequency until you find a clean channel.

• Set the required audio output level (If not sure about output level, this can be set after TX mic gain

has been set)

Transmitter (TX) Setting Up

• Fit a PP3 9V battery

• Connect provided TX antenna (flexible SMA antenna)

• Set your TX frequency same as RX

• Switch on TX (by connecting microphone cable to 6-pin Lemo or 4-pin Hirose socket)

• Check TX battery status LED, if RED replace TX battery with a new one

• Check RX Received Signal Strength Indicator – LED should be GREEN

• Adjust SET LEVEL gain control, while the performer speaks at correct level so that AF Peak LED comes on

all the time, then set gain back by TWO notches - at which AF Peak LED flashes occasionally.