User`s manual

Micron Electronics, Inc.1-16
Micron ClientPro XVI User's Guide
Tower Case
Refer to the Figure on the following page. Use a #2 phillips-head screwdriver or a1/4"
hex driver.
1. It is not necessary to disconnect the cable connectors on the back of the
computer before opening the cover. However, note where the cables connect
to the back for future reference . (If you have a video camera, a quick scan of
the rear case is helpful).
2. Remove the screws from the back of the case cover. Keep these screws
together (they are a different size than the other screws in your system) for they
are not to be interchanged.
3. With flat palms placed on each side of the cover, pull the cover back until the
cover's front top lip clears the chassis channel (about 3/4"). Grasp the top-rear
of the cover and lift up in one smooth motion until the cover clears the chassis.
To replace the cover, gently lower the top lip of the cover into the chassis channel at an
angle before lowering the rear into place. With the lip inserted in the channel, push the
rear of the cover forward to seat it flush and replace the screws. Note the metal rail guides
located inside the bottom of the cover which must fit over the bottom metal case frame
when the cover is replaced.