User`s guide

DVD Installation and Setup Chapter Six - Optional Accessories
93
W
ARNING
:
Do not detach the notebook computer and port replicator by force or when
the notebook computer is still running any applications. Follow any of the
”Disconnecting by Hardware Application” procedures on how to disconnect
the notebook computer from the port replicator. Failure to do this will
definitely cause a major hang-up on the notebook computer as well as the
port replicator.
After the internal components are completely disconnected, you are now ready to
separate the notebook computer and port replicator manually by following the
steps below:
1. Pull the lever arm forward to completely separate the notebook computer and
the port replicator.
2. Lift up the notebook computer away from the guiding slots of the port
replicator.
DVD Installation and Setup
The following section will help you setup and utilize your new DVD hardware.
Please follow these instructions carefully.
N
OTE
: If you purchased your TREK 2 with DVD, all of this has already been setup and
configured for you. You do not need to complete any of these instructions.
Installation
Close the LCD on your TREK 2, make sure that the power is turned off, and the
battery and A/C cord have been removed before proceeding.
1. Remove the CD-ROM drive from the bottom of your TREK 2 by sliding the
small tab under the front edge of the notebook to the left hand side.
2. Insert the DVD-ROM drive into your TREK 2 where the CD-ROM drive just
came out of. Open the LCD assembly and power on your TREK 2.
N
OTE
: Please select cancel for any new devices that are found during the Windows 95 or
98 boot.
Once Windows 95 or 98 has loaded insert your Micron Electronics, Inc. MCRC
CD into the DVD-ROM drive, select the DVD icon, and follow all the instructions
carefully.