User`s guide

Installing Optional Devices Chapter Six - Optional Accessories
92
8. Once both of them are aligned properly, press the notebook computer
downward to fully attached it to the port replicator.
9. Be sure the notebook computer is properly aligned and secure.
10.Pull the lever arm forward to plug the 204-pin port replicator connector on the
rear panel of the computer into the computer connector on the front panel of
the port replicator.
11.Press the Power/Suspend/Resume button to turn on the computer.
N
OTE
:
You can use the DC adapter of the notebook computer or just use the battery
pack to supply power during operation.
Disconnecting by Software
Application
Click the Start button and select the Eject PC option to disconnect the two units.
The notebook computer will enter the Suspend Mode. Press the Eject button then
push the Lever Arm backward to totally disconnect the two units.
Disconnecting by Hardware
Application
Procedure 1
You can also press the Eject button on the port replicator to enter the Suspend
Mode. The Suspend Status indicator icon on the LED panel of the notebook
computer will light to indicate its mode.
Press the Eject button for the second time to disconnect the internal components
of the notebook computer from the port replicator; the LED on the port replicator
will be shut off. Push the Lever Arm backward to totally disconnect the two units.
Procedure 2
Press the Power button to enter Suspend Mode; press the Eject button of the port
replicator then pull the Lever Arm to totally disconnect the two units.
N
OTE
:
The LED indicator on the front panel of the replicator shuts off automatically after
you have successfully executed any of the above two procedures.