User`s guide

Installing Optional Devices

Chapter Six - Optional Accessories

If ordered with your TREK 2, Micron has already installed all necessary software

for your modem to be recognized by your operating system.

To install the Modem driver, please follow these steps:

1. During the Windows 95/98 boot procedures, a New Hardware Found display

window is detected and shown on your window screen. Skip and ignore this

message

2. Insert the Driver CD into the CD-ROM drive, select the Modem directory and

double click Setup to begin with the installation.

3. Follow the on-screen procedures to finish the installation. Restart the

computer.

4. Locate the driver entry by clicking the Start button then click Settings.

5. Click the Control Panel item and select System.

6. From the System Properties window, click the Device Manager tab.

7. Select Modem and check on the LT Modem entry.

AT Command Set Executing

Commands

Commands are accepted by the modem while it is in Command Mode. Your

modem is in Command Mode by default, until you dial a number and establish a

connection. Commands may be sent to your modem from a PC running

communication software or any other terminal devices.

Communication STd. V.90 (56 K model) for hi

hest Internet connection rate

V.34+, V.34, V.32bis, V.32, V.29, V.27ter, V.22bis, V.23, V.22,

V.17, Bell212/103

Data Compression V.42bis/M N P5

Fax Group Group III Send/Receive Standard

Fax Command Set EIA/TIA - 578 Service Class 1

Error Correction V.42/M N P2-4

Host Interface 100-pin connector 32 bit PCI Bus

PnP Revision 1.0a

Transmit Level -9dBm

Receiver Sensitivity 36dBm (V.34+)l -40dBm (all other protocols)

DTE Speeds 300-115200 bps

Temperature 0-55 de

rees C (operatin

); -20-80 de

rees C (non-operatin

)

TABLE 9. Modem Specifications