User`s guide

Power Saving Modes Chapter Five - Power Management
73
To remove the battery pack:
1. Turn off the computer.
2. Open the battery bay door. Slide the battery release latch to the left.
3. Lift the battery finger grip and pull the battery from the bay.
Power Saving Modes
This section contains information on the TREK 2’s power system, including the
AC adapter, the battery system, recharging the battery, and tips for conserving
battery power. Also included are detailed descriptions of power management and
each of the power modes.
The power system is comprised of two parts, the AC adapter and the battery
system. The AC adapter converts AC power from a wall outlet to the DC power
required by the computer. The battery pack is a set of lithium-ion (Li-Ion) or nickel-
metal hydride (Ni-MH) batteries housed in a plastic shell. There is one pack
inserted in the battery housing of the computer.
AC Adapter
The AC Adapter’s primary function is to provide power to the TREK 2. When the
adapter is connected to the computer, it provides power as long as it is plugged
into an electrical wall outlet. If the AC Adapter is not functioning properly, please
consult your dealer immediately for support.
Battery Power System
The TREK 2’s Li-Ion removable battery pack is found in the battery compartment.
A fully charged pack will provide approximately three to four hours of battery life.
The battery life can be extended by using the power management features. The
battery system implements the smart battery standard which allows the battery to