User`s guide

ManualsBrandsMicron Electronics ManualsComputer equipmentTREK 2 AGP

Security Menu

Chapter Three - Running BIOS Setup

Passwords

You can specify passwords in the

Security

menu. The passwords control access

to the BIOS and certain

Security

menu options during system startup.

The passwords are not case sensitive. In other words, a password can be entered

using either upper or lower case letters; it makes no difference. If you forget your

password, your system will have to be sent to Micron to have it removed at your

expense.

User Password Is

This field shows

Set

when you have set a User Password. If you have not set the

User Password, the field will show

Clear

. This is a display only field.

Supervisor Password Is

This field shows

Set

when you have set a Supervisor Password. If you have not

set the Supervisor Password, the field will show

Clear

. This is a display only field.

Set Supervisor Password

To set the

Supervisor

password, highlight this field and press the [Enter] key. The

following dialog box appears:

Type the password and press the [Enter] key. You can type up to seven

alphanumeric characters. Symbols and other keys are ignored. To confirm the

password, type the password again and press the [Enter] key. The

Supervisor

password is now set. This password allows full access to the BIOS Setup menus.

To clear a password, highlight this field and press the [Enter] key. Press the

[Enter] key twice. The password is now cleared.

OTE

Large Disk Access mode controls how the disk controller accesses the disk

volume. Setting the option to Other may cause the hardware not to recognize

DOS, Windows or other DOS based operating system disk formats.

Set User Password

To set the User password, follow the same instructions for setting the Supervisor

password. The User password allows restricted access to the Setup menus. This

password also requires that the Supervisor password be set prior to setting the

User password.

This option requires prior setting of the Supervisor password to function. When

enabled, the system will then require either the Supervisor or User password

before the system can bootup.