User`s guide

Adding/Upgrading Memory Chapter Two - System Features
39
Adding/Upgrading Memory
To upgrade memory, perform the following steps:
1. Above the [F2] key and the [Insert] key (Ins), there are slider tabs. Slide these
tabs inward toward the center of the keyboard.
2. Take a standard sized pen and place it in the uncovered section of the tab.
3. Gently push the pen toward the LCD and lift the keyboard upward. Your
keyboard should easily lift up and fold toward the front of the machine.
4. Lift the silver shield up and away.
5. The upgraded, larger capacity memory module should always be placed in
Slot 0, which is the slot closest to the battery compartment.
6. If a smaller capacity module is already populating Slot 0, move the tabs
outward slightly to release the module. Remove the memory module at a 45
degree angle.
7. Insert the new, larger capacity module at the same 45 degree angle. Press
gently until you hear a click.
8. Continue this process with additional memory modules in the left slot (Slot 1).
W
ARNING
:
Use only SDRAM memory modules.
Preparing the TREK 2 for
Transport
To prepare the computer for transport, you should first disconnect all peripherals.
Make sure the computer is turned off before you do this. After disconnecting all
peripherals, close the rear port covers to protect the connectors.