User`s guide

TREK 2 Keyboard Chapter Two - System Features
30
Adjusting the LCD Screen Display
The LCD screen display can be adjusted by the following key combinations.
LCD Care
LCD screens are delicate devices that need careful handling. Please take the
following precautions:
•
When you are not using the computer, keep the LCD screen closed to
protect it from dust.
•
If you need to clean your LCD screen, use a soft tissue to gently wipe the
LCD surface.
•
Do not put your fingers or sharp objects directly on the surface or spray
cleaner onto the display.
•
Do not press on or store any objects on the cover when it is closed. Doing
so may cause the LCD to break.
External CRT Display
You can hook up an external monitor through the 15-pin CRT connector. Three
configurations are available:
•
LCD only
•
Simultaneous display of the LCD screen and CRT monitor
•
CRT only
You can switch between these display configurations by pressing the key
combination [Fn] + [F12].
TREK 2 Keyboard
The TREK 2’s keyboard uses a standard QWERTY layout with the addition of
special function keys and an embedded numeric keypad, and supports Windows
95 by incorporating the two Windows specific keys so you can take advantage of
many of the time-saving features of Windows 95.
The QWERTY layout means the alphanumeric keys located on the keyboard are
in the same position as those found on a standard typewriter.
Key Combinations Definitions
[Fn] + [F7] Decrease bri
g
htness level
[Fn] + [F8] Increase bri
g
htness level
[Fn] + [F12] Switch between LCD and CRT displays
TABLE 2. Screen Display Definitions