User`s guide

4-6 Micron Electronics, Inc.
Micron NetFRAME LV2000 Server System User’s Guide
System Problems
Problem
A large number of damaged sectors are encountered when attempting
to format diskettes.
Possible Cause
❏ Typically, Micron computers are provided with a 1.44MB 3.5"
floppy drive. An attempt may have been made to format a low-
density disk in one of the Micron high-density floppy drives.
Solution Checklist
❏ Please refer to the DOS manual for more information about how
to format low-density diskettes in high-density floppy drives.
Problem
The IDE CD-ROM is not being recognized by the system.
Possible Cause
❏ CMOS is configured incorrectly.
❏ The connection to the CD-ROM is improper or loose.
Solution Checklist
❏ Check in the system’s CMOS Setup to ensure that the
PERIPHERAL CONFIGURATION mode is set to Auto. For help
in getting to your CMOS settings, see Chapter 3 - The BIOS Setup
Program.
❏ With the power OFF, carefully open the system unit. Reconnect
the CD-ROM ribbon cable on the motherboard and at the back
of the CD-ROM. To assist you, the colored stripe going down
the side of the gray controller cable signifies pin one and should
be connected to pin one of the controller and drives. Also, check
to ensure that the power connector in the CD-ROM is secure.