LTE Tracker Bolt Mini 2A User Manual Revision: 1.00 Document Title Bolt Mini 2A User manual Version 1.
Contents 1 Introduction ................................................................................................................................... 3 2 Product Overview ........................................................................................................................... 3 2.1 Appearance ......................................................................................................................... 3 2.2 Key/USB Interface Description ....................................
1 Introduction Bolt Mini 2A is a powerful GPS locator which is designed for vehicle and assets tracking. It works on LTE CATM1 B2/B4/B12/13 with superior receiving sensitivity. Its location can be real time or schedule tracked by back‐end server or specified terminals.
2.2 Key/USB Interface Description Button /12PIN Interface Description KEY/interface Description Power Key The Bolt Mini 2A can be powered on by putting the switch to “On”. USB interface Connected to a debug cable can change configure to Bolt Mini 2A Back‐end server developer or administrator can use the debug cable to configure Bolt Mini 2A (by engineer not by end user). 2.3 LED Description Figure 1‐2 There are four LED lights in Bolt Mini 2A device, the description as following.
3 Getting Started 3.1 Parts List Name Picture Remark Bolt Mini 2A Locater The LTE/GPS locator. 3.2 Battery Charging The following items are suggestion for battery charge, please pay more attention. Note: The Bolt Mini 2A device cannot be charged, It is recommended to use standard AA battery for the device. 3.
Power on: The Bolt Mini 2A can be powered on by putting the switch to “ON”. Power off: The Bolt Mini 2A can be powered off by putting the switch to “OFF”. . 3.4 How to use 3.4.1 Insert a 4G SIM into the product 3.4.2 Insert 8 AA batteries into the device as per indications . 3.4.3 The Bolt Mini 2A can be powered on by putting the switch to “ON”. 3.4.4 BLE Use the USB cable to configure the software of the product (the software will define that the product will automatically open BLE function).
5 Trouble shooting and Safety info 5.1 Trouble shooting Trouble Possible Reason Solution Messages can’t be reported to the backend server by Mobile network. APN is wrong. Some APN can not visit the internet directly. Ask the network operator for the right APN. The IP address or port of the backend server is wrong. Make sure the IP address for the backend server is an identified address in the internet. Unable to power off Bolt Mini 2A. The function of power key was disabled by AT+GTFKS.
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. (1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may ause undesired operation. §15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. §15.
