CDMA/GPS Tracker Prime ATC User Manual Revision: 1.00 Document Title Prime ATC User manual Version 1.
Contents 1 Introduction....................................................................................................................................3 2 Product Overview ..........................................................................................................................3 2.1 Appearance..........................................................................................................................3 2.2 Buttons/Micro USB Interface Description...............................
1 Introduction Prime ATC is a powerful GPS locator which is designed for vehicle, pets and assets tracking. With superior receiving sensitivity, fast TTFF and CDMA frequencies 800/1900. Its location can be real time or schedule tracked by backend server or specified terminals.
KEY/interface Description Power Key Power on Prime ATC Power off Prime ATC (If power key is enabled) Function Key Geo-Fence mode Long press the key to enable/disable Geo-Fence ID0 Geo-Fence in current position mode Long press the key to enable/disable Geo-Fence ID0. If enable Geo-Fence ID0, using the current position as the centre of Geo-Fence 0.
Power key was pressed and prepare to power off Fast flash (red) Power key was pressed and prepare to power on Fast flash (green) 3 Getting Started 3.1 Parts List Name Picture Remark Prime ATC Locater The CDMA/GPS locator. AC-DC Power Adapter It is used to charge the internal battery of Prime ATC. Prime ATC Data and charger Cable It the USB data cable which can be used for firmware upgrading and configuration. It also includes the charger interface on the Prime ATC. 3.
which will make the life of battery much longer. 3.3 Prime ATC Data Cable Prime ATC Data Cable is a cable with a Micro USB connector. The USB data cable is used for data download, which will be used for firmware update or configuration and can be used for charging at the same time. Figure 2-1 3.4 Power on/Power off Figure 2-2 Power on: Press the Power key at least 3 seconds and release it to power on Prime ATC device. Note that, the Power LED light will fast flash.
4 Trouble shooting and Safety info 4.1 Trouble shooting Trouble Possible Reason Solution Messages can’t be reported to the backend server by GPRS. APN is wrong. Some APN can not visit the internet directly. Ask the network operator for the right APN. The IP address or port of the backend server is wrong. Make sure the IP address for the backend server is an identified address in the internet. Unable to power off Prime ATC. The function of power key was disabled by AT+GTFKS.
FCC Caution. § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.
user's body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. Body-worn Operation This device was tested for typical body-worn operations.
