Installation Owner's manual

MOD 30ML Multiloop Controller
MODULAR I/O CONNECTIONS
4.3.6 2009A RTD Input (RIM, WRIM)
Make resistance input connections as shown in Figure 4-8. The 2 wire input module (RIM),
uses a single wide case and the 3 wire input module (WRIM) uses a double wide case. Table
4-2 summarizes the RTD support standards and shows some sample RTDs.
Table 4-2. Supported RTD Materials and Standards and Sample RTDs
Sample RTDs and Appropriate Module Supported RTD Materials and Standards
 @ 0°C Approx.  Range
RTD Module Material
Alpha (/-/°C)
Standard
1000 184.94 to3902.61 2 Wire Platinum 0.003850 DIN 43760 (Note 1)
500 92.47 to 1951.31 2 Wire Platinum 0.003850 DIN 43760 (Note 1)
1000 555.00 to 3169.25 2 Wire Nickel 0.006720 Minco (Note 2)
100 18.49 to 390.26 3 Wire Platinum 0.003850 DIN 43760 (Note 1)
98.129 16.66 to 311.87 3 Wire Platinum 0.003923 SAMA RC21-4
100 17.07 to 332.62 3 Wire Platinum 0.003902 Burns
100 17.26 to 403.70 3 Wire Platinum 0.003911 Minco (Note 2)
120 66.60 to 380.31 3 Wire Nickel 0.006720 Minco (Note 2)
1. Also meets IEC 751 and BS 1904 Standards.
2. Sometimes called U.S. Industrial Standard.
Input specifications for the 2 wire and the 3 wire input modules are:
RTD INPUT
Range (0 to 100%):
2 Wire: 0 to 4000 Ohms
3 Wire: 0 to 400 Ohms
Low limit: 0 Ohms
High limit:
2 Wire: 4200 Ohms
3 Wire: 400 Ohms
Module Counts (0 to 100%): –25000 to 25000 (converted to 0 to 50000 in controller)
Sensitivity (One Count)
2 Wire: 0.08 Ohms
3 Wire: 0.008 Ohms
Accuracy, calibrated at 5V supply and 25°C: ±0.05% of Range
(This equals an absolute accuracy of ±25 counts or ±2 ohms for the 2 wire input or
±0.2 ohms for the 3 wire input or ±0.519°C for the Platinum DIN 43760 curve)
Temperature Effect (0°C to 50°C): 0.1% of Range
Noise filter: 3 db at 5 Hz
Max Resistance Each Lead: 100 Ohms
Excitation Current (maximum)
2 Wire: 0.25 mA
3 Wire: 0.6 mA
Burnout Detection on all leads: Upscale
Isolation: 250 Vrms
Common mode rejection: 100 db at 60 Hz minimum
Normal mode rejection: 40 db at 60 Hz minimum
62