Maintenance for 2001N, 2002N, and 1800R Manual

MOD30ML and Modcell Maintenance Manual
EVENT CODES AND TRANSITION MESSAGES
SECTION 7
EVENT CODES AND TRANSITION MESSAGES
7.1 GENERAL
The transition messages and diagnostic and informational event codes described
in the following sections can be viewed on the status display in the Application
Builder or ViZapp Software or from the MOD 30ML display. Refer to Section 3 for
information on accessing the status display, and issuing the commands required to
read the codes and messages.
7.2 TRANSITION MESSAGE DESCRIPTIONS
Table 7-1 lists the event transition messages and their descriptions. These transition
messages apply to all events for all blocks.
Table 7-1. Event Transition Messages Descriptions
Message Description
INFOONLY An informational event. No appended text required.
UAK-ONLY Indicates the acknowledge only diagnostic has occurred.
UAK-ONLY Indicates the acknowledge only diagnostic has occurred.
ACT/UAK Indicates the event has gone active and unacknowledged.
ACT/ACK
Indicates the process alarm has gone active but not unacknowledged because its
priority level is zero.
ACT/UAK Indicates the event has gone active while it was unacknowledged.
CLR/UAK Indicates the event has cleared while it was unacknowledged.
CLR/ACK Indicates the event has cleared after it was acknowledged.
CLR-SUPP Indicates the event was cleared by one of the suppression methods.
ACKED Indicates the event was acknowledged by a single ack message.
GLBL ACK Indicates the event was acknowledged by one of the global ack methods.
ACK-SUPP Indicates the event was acknowledged by one of the suppression methods.
SUPP Indicates the event’s suppression attribute has been set to YES.
ENABLED Indicates the event’s suppression attribute has been set to NO.
7 -1