Users Guide User Manual

IB-23C003
INSTALLATION
Table 2-6. Mini Link External Serial Port Baud Rates
* Not recommended for use with currently available software.
BAUD
Jumper IN
W12 W11 W10 W9 W8
76800* Y NNNN
38400* N Y N N N
19200 N N Y N N
9600 N N N Y N
Clear-To-Send (CTS) for Serial Ports 1 and 2
Both the PC/AT and the External Serial Ports are outfitted with a CTS connection. In most
cases, the CTS signal will not be needed. In the event that your configuration requires a
CTS signal, install jumpers W1 and W2 as follows:
W1 Enables Clear To Send on External Serial Port 2
W2 Enables Clear To Send on PC/AT Serial Port 1
RS-232 Test Signal Jumper
Jumper W22 provides access to the 5V power plane of the Mini Link. If Jumper W22 is
connected, the 5V signal will appear on pin 9 of the RS-232 connector. This jumper will
normally be used for test purposes only.
2-5