Installation and Setup Manual

Micro-PWC™ Installation & Setup Guide
18 Installation
3.4.1.5 Inserting the Supervisor Board
This sub-section details the steps needed to insert the Supervisor board in the expansion slot of the per-
sonal computer on which the Micro-PWC system software will be installed.
Figure 3-3. Jumper Settings, Supervisor Board
J3 J4 J5 Base Address
AB AB AB 300H
AB AB BC 310H
AB BC AB 380H
AB BC BC 390H
BC AB AB 3A0H
BC AB BC 280H
BC BC AB 290H
✎ NOTE The internal configuration of personal computers can vary between
models and between manufacturers. If you have questions about
the internal layout of your PC, or difficulty in following the steps
below, refer to the documentation that came with your computer.
∆ WARNING
The Supervisor board will be installed in a computer which
operates with possibly lethal voltages. Before removing the
computer cover, observe the precautions shown in
Step 1
below, to provide personal protection and prevent damage to
the systems components.