Configuration Guide User Manual

Micro-PWC CONFIGURATION GUIDE
Grafx Editor 201
Variables
dir Enter the tagname.atom of a point in the controller database, or enter the value
representing the direction in which the wheel will "spin" (see table below)
(User must define variable.)
DIRECTION VALUE
clockwise
1
counterclockwise
0
on_tagatom Enter the tagname.atom of a point in the controller database (i.e., DCD_0.OUT1;
the value of this point is used by the variable on_value (described below) to
activate the "spin" dynamic attribute of the submodel.
(User must define variable.)
on_value Enter a value; the value entered here will be compared with the value of the
controller database point configured in the variable on_tagatom. When the value
of the tag.atom matches the value configured here for on_value, the wheel will
appear to "spin".
(User must define variable.)
period Enter the frequency at which the wheel spokes will appear to change position.
The period is measured in tenths of a second; the number entered here defines
how many tenths of a second are in the period (e.g., a "5" entered here means
the period would be .5 seconds in duration). NOTE: The higher the number used
to define the period, the slower the object will appear to "spin".
Default: 1 (One tenth of a second.)
spoke_color Enter the index number of the color to be used for the wheel spokes.
Default: 0 (Black)
wheel_color Enter the number of the color to be used for of the wheel interior.
Default: 0 (Black)