Configuration Guide User Manual

Micro-PWC CONFIGURATION GUIDE
174 Grafx Editor
Variables
button_label Enter the label to be displayed on the button (e.g., A).
Default: None
on_value Enter the value of the controller database tag.atom configured in the variable
statatom that will set the status "light" on. The comparison applies only for
integer-type values.
Default: 0
put_tagatom Enter the Tag.atom of the controller database point to which the data
configured in put_value will be written (e.g., tcPID.AUT).
Default: None
put_tagatom2 Enter the Tag.atom of the controller database point to which the data
configured in put_value2 will be written.
Default: None
put_tagatom3 Enter the Tag.atom of the controller database point to which the data
configured in put_value3 will be written.
Default: None
put_tagatom4 Enter the Tag.atom of the controller database point to which the data
configured in put_value4 will be written.
Default: None
put_value Enter the value that will be written to the controller database point configured
in put_tagatom (e.g., 1).
Default: None
put_value2 Enter the value that will be written to the controller database point configured
in put_tagatom2.
Default: None
put_value3 Enter the value that will be written to the controller database point configured
in put_tagatom3.
Default: None
put_value4 Enter the value that will be written to the controller database point configured
in put_tagatom4.
Default: None
statatom Enter the Tag.atom of the controller database point that sets the status "light"
on when its value is equal to on_value (e.g., tcPID.AUT).
Default: None
(User must define variable.)