User guide

Training Manual
Micro-Tools Lab
8 - 3
Figure 8.2.
Super32 Tree View
Figure 8.3.
Super32 Tree View
• Assuming that the Controller is connected to the computer and the
communications port settings as configured for 9600 baud, 8 Databits, No Parity,
you should be able to see SERIAL1 network (or other networks) and the Controller
attached to the network as shown in the next figure.
• The networks were configured at the time of installation during the Micro-DCI
Communication Services setup (in the MicroTools Installation Lab).
Communication networks can be added or removed using the Super32 application