User guide

Training Manual
Advanced Configuration Lab
6 - 5
2. Select Parameter Module 0
• Using the / buttons, select the PARAMETER Module configuration from the
menu list.
• Press F3 to enter the Parameter module configuration.
• Select Parameter Module 0, 0-CON-0 TUNE using the / buttons.
• Press F3 to enter Parameter 0 configuration menu.
3. Parameter Module 0 parameter configuration
• Select and modify the module tag name. Using the
/ pushbuttons, select
TAG : CON-O TUNE and press F3 to change the tag name. Change the tag
name to MATH DEMO. Remember to use the F2 fushbutton when making
changes to the tagname.
• When the tag name has been changed, press F3 to accept the changes and return to
the previous screen.
• Continue making changes to the remainder of the Parameter module using the
information supplied in Table 5.2
Table 6.2.
Parameter display
Locations
Location Legend Default value for
the CON0 TUNE
display
Change the value to
the following:
A010 Tag CON-0 TUNE MATH DEMO
A011 Point A Name
(PNA)
PROP. BAND INPUT 0
F084 Point A
Designator (PDA)
C106 C090
A012 Point B Name
(PNB)
RESET TIME INPUT 1
F085 Point B
Designator (PDB)
C107 C091
A013 Point C Name
(PNC)
DERV. TIME RESULT
F086 Point C
Designator (PDC)
C108 C030
4. Exit Engineering Mode