User guide

Training Manual

Front Face Configuration – Single Loop Lab

3 - 3

Figure 3 .2.

MC 5000 display

and buttons

2. Select the data point B0 to default the controller (to return the instrument’s

configuration to factory default settings):

• Be certain that the “cursor”

is in the right most character position by pressing the

output increase

pushbutton.

• Press the setpoint-increase

pushbutton until the letter B is located in the lower

right corner of the display.

• Move the letter B to the left by pressing the output decrease

pushbutton once.

You will now notice that the letter B moves to the left one character position and a

blank character position is added.

• Press the setpoint-increase

pushbutton until the number 0 is displayed next to

the “B” character. The bottom line of the display should look like:

POINT