User guide

Training Manual

F-CIM Lab

9 - 23

Figure 9.21.

CONFIGURE

12. Run the F-CIM program: Press the F3 button while CONFIGURE is displayed at the

bottom. The display will show POINT

at the bottom.

• Press F3 to accept the configuration mode. On design level A controllers, the

bottom line should now display the following: POINT

. On a design

level B controller, the bottom line should read DATAPOINT or MODULE .

Press the F2 button until DATAPOINT 5 is displayed.

• Press F3 to accept the DATAPOINT configuration mode. The bottom line should now

display the following: POINT

• Use the UP/DOWN/RIGHT/LEFT arrow keys to enter B00 at the bottom and then

press the F3 key to select it.

• Enter a value of 99 and then press the F3 key. Now the controller should start

running the F-CIM program you did and the display should look like the next

figure: