User guide

Training Manual
F-CIM Lab
9 - 22
Figure 9.20.
PROGRAM
11. Enter the CONFIGURE mode: An important step in F-CIM programming is that after
completing the code entry into the controller, you should tell the controller to run the F-
CIM program. This can be achieved by changing the Function Index (Data point B000) of
the database to a value of 99.
• If PROGRAM is displayed at the bottom, press F2 until CONFIGURE is
displayed at he bottom.
• If nothing is displayed at the bottom, press the EMODE button (Dot button /F4
button) and then the F2 button to display CONFIGURE at he bottom.