User guide

Training Manual
F-CIM Lab
9 - 20
• Program Step 01 from here. Refer to the Worksheet in Table 9-3 for the function
code and inputs A, B and C. Follow the same procedure as the previous step except
for the values to be entered.
• If no changes are to be made to a particular data position, press the F2 key to cycle
to the next data position. Refer to the F-CIM Program Flow diagram in Figure 9-15
for help.
• After you have entered Steps 02 through 06, at the end of Step 06, your display
should look like the next figure:
Figure 9.18.
FCIM BUILD
9. Exit the Build mode:
• Press the F1 button now. Your display should look like the figure below: