User guide

Training Manual
F-CIM Lab
9 - 13
Figure 9 .8.
FCIM BUILD
• The bottom line will display STEP? This means that you are prompted to enter the
STEP number to modify. Use the UP/DOWN (Setpoint Increase or Setpoint
Decrease) pushbuttons along with the LEFT/RIGHT arrow (Output Increase or
Output Decrease) pushbuttons to select step number 00.
• Press the F3 to accept step 00.
Figure 9.9.
FCIM BUILD
• A controller will display the screen containing the parameters for this particular
step. The step number is at the top, the function module ID (Function Code)